TM 5-5420-226-20-3
MASTER CONTROL PANEL REPAIR (Sheet 64 of 73)
Master Control Panel Wiring Harness RepIacement (Sheet 1 of 7)
PROCEDURE INDEX
PROCEDURE
PAGE
Removal
Installation
TOOLS:
3/8 in. combination box and open end wrench
Offset cross-tip screwdriver
Flat-tip screwdriver
3/8in. socket with 1/2 in. drive
11/32 in. open end wrench
SUPPULIES: Silicone compound (Item 32, Appendix D)
REMOVAL:
1.
Using flat-tip screwdriver on screws (A)
and 11/32 inch wrench on nuts (B), remove
four screws (A), lockwasers (C), and
nuts (B) securing connector (D) to panel
(E).
2.
Remove connector (D) from panel (E) and
position aside.
Using flat-tip screwdriver on screws (F)
3.
and 11/32 inch wrench on nuts (H), remove
nuts (H) securing connector (J) to panel
(E).
4.
Remove connector (J) from panel (E) and
position aside.
Go on to Sheet 2
TA168752