TM 5-5420-226-20-3
RIGHT TAILLIGHT - STOPLIGHT ASSEMBLY REPLACEMENT (Sheet 1 of 3)
TOOLS:
9/16 in. combination box and open end wrench
Silicone compound (Item 32, Appendix D)
SUPPLIES:
1/2 in. masking tape (Item 58, Appendix D)
Pencil
PRELIMINARY PROCEDURES: Remove transmission shroud (page 9-2)
NOTE
Inspect leads (A) and leads (B) for
numbered tags (C) 23 and 24. If
leads do not have tags, use masking
tape and pencil to number leads.
1. Reach through exhaust door
opening and disconnect two leads
(A) from hull connectors (B).
2. Slide two connector shells (D) back on
taillight leads to expose two slotted
washers (E).
NOTE
Lubricant be needed on leads
(A) to remove shells (D).
3. Remove two slotted washers (E) and two
shells (D).
TA168861
Go on to Sheet 2
