TM 5-5420-226-20-3
ENGINE STARTER WIRING HARNESSES REPLACEMENT (Sheet 4 of 7)
INSTALLATION:
NOTE
Note polarization. Two small holes
go on bottom.
1. Using flat-tip screwdriver and 3/8 inch
wrench, secure female connector (A) to
bracket (B) using four screws, lockwashers,
and nuts (C).
2. Manually connect electrical connectors .
(E).
3. Using 7/16 inch wrench and 7/16 inch socket,
install nut and screw (F) to secure ground
wire (G) to bracket (H).
4. Feed female connector cables between exhaust
manifold (J) and engine.
TA168928
Go on to Sheet 5