TM 5-5420-226-20-3
ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR (Sheet 3 of 18)
Male Plug Repair (Sheet 2 of 3)
Using hand wire stripper, strip insulation
7.
from jumper wire equal to depth of
contact solder well (F).
8. 1Placing connector face down on flat surface,
apply a small amount of silicone to
empty holes on back of plug assembly (B)
and on front of grommet (D).
9. Push new contact (E) into hole in back of plug
assembly (B) far enough so it will remain
standing.
10. Push jumper wire end, first through grommet
retaining-nut (A) and then through hole in
grommet (D).
11. Hold jumper wire so wire end is pushing
down on solder in contact solder well (F).
12. Hold soldering gun tip against side of
contact (E) until solder begins to melt and
wire slips into contact solder well (F).
13. Removing soldering gun from side of
contact (E), continue holding wire until
solder has cooled and set.
Go on to Sheet 3
10-300