TM 5-5420-226-20-3
ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR (Sheet 8 of 18)
Female Plug Repair (Sheet 1 of 3)
Electrical connector repair toolkit
TOOLS:
Soldering gun
Slip joint pliers with plastic jaw inserts
Diagonal cutting pliers
Pocketknife
SUPPLIES:
Silicone compound (Item 32, Appendix D)
Electrician's tape (Item 59, Appendix D)
Jumper wire
Disconnect three battery ground straps (page 10-268)
PRELIMINARY PROCEDURES:
Loosen or remove cable clamps as required
Disconnect connectors at each end of affected cable
1. Manually remove grommet retaining nut(A)
from plug assembly (B).
2. Slide grommet retaining nut (A) back
along cable (C).
3. Using slip joint pliers, work
grommet (D) back and forth and
out of plug assembly (B).
4. Using remover, push contact
(E) with damaged wire out of
back of plug assembly (B).
TA168956
Go on to Sheet 2