TM 5-5420-226-20-3
ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR (Sheet 10 of 18)
Female Plug Repair (Sheet 3 of 3)
11. Hold jumper wire so wire end is pushing
down on solder in contact solder well (F).
12. Hold soldering gun tip against side of
contact (E) until solder begins to melt
and wire slips into contact solder well (F).
13. Removing soldering gun from side of
contact (E), continue holding wire until
solder has cooled and set.
14. Using remover, push contact (E)
into plug assembly (B).
15.
Sliding grommet (D) forward along
cable (C), set grommet (D) firmly against
contacts (E).
Manually thread grommet retaining nut (A)
16.
onto plug assembly (B).
17.
Using multimeter, check continuity of repaired circuit.
Tighten or install cable clamps as required.
18.
Connect connectors at each end of affected cable.
19.
20.
Connect three battery ground straps (page 10-268).
End of Task
TA168958
10-307