--
TM 5-5420-226-20-3
ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR (Sheet 11 of 18)
Female Plug Repair (Sheet 1 of 3)
TOOLS:
Electrical connector repair tool kit
Soldering gun
Slip joint pliers with plastic jaw inserts
Diagonal cutting pliers
SUPPLIES:
Silicone compound (Item 32, Appendix D)
Electrician's tape (Item 59, Appendix D)
Jumper wire
PRELIMINARY PROCEDURES:
Disconnect three battery ground straps (page 10-268)
Loosen or remove cable clamps as required
Disconnect connectors at each end of affected cable
1. Manually remove grommet retaining nut (A)
from plug assembly (B).
2. Slide grommet retaining nut (A) back
along cable (C).
3. Using slip joint pliers, work
grommet (D) back and forth and
out of plug assembly (B).
4. Using remover, push contact (E) with
damaged wire out of back of plug
assembly (B).
Go on to Sheet 2
TA168959
