TM 5-5420-226-20-3
ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR (Sheet 18 of 18)
Female Receptacle Repair (Sheet 3 of 3)
14. Using remover, push contact (E) into
plug assembly (B).
15. Sliding grommet (D) forward along
cable (C), set grommet (D) firmly against
contacts (E).
16. Manually thread grommet retaining nut (A)
onto plug assembly (B).
17. Using multimeter, check continuity of repaired circuit
18. Tighten or install cable clamps as required.
19. Connect connectors at each end of affected cable.
20. Connect three battery ground straps (page 10-268).
End of Task
TA168966
10-315
