TM 5-5420-226-20-3
FUEL TANK CAPACITOR AND HOUSING ASSEMBLY REPLACEMENT (LEFT) (Sheet 1 of 5)
PROCEDURE INDEX
PAGE
PROCEDURES
Removal
Installation
Slip-joint pliers
Flat-tip screwdriver
TOOLS:
1/2 in. socket with 1/2 in. v drive
Diagonal cutting pliers
Ratchet with 1/2 in. drive
Putty knife
Torque wrench with 1/2 in. drive (0-175 lb-ft)
SUPPLIES:
Dry cleaning solvent (Item 55, Appendix D) Gaskets (10864012)
Gasket (1870952) (3 required)
Lint-free cloth (Item 12, Appendix D)
Lockwire (Item 61, Appendix D)
REFERENCE:
Remove powerplant (page 5-2).
PRELIMINARY PROCEDURES:
Drain left fuel tank (TM 5-5420-226-10)
REMOVAL:
1.
Remove electrical connector (A) from capacitor and housing electrical connector (B) by
pulling out.
Using diagonal cutting pliers, remove lockwire (C) securing four screws(D) on capacitor
2.
and housing (E).
Using screwdriver, remove four screws (D),
flat washers (F), and lockwasher (G) from
capacitor and housing (E).
Slowly separate capacitor and housing(E)
4.
from cover(H). Capacitor and housing (E)
are connected to cover (H) with an electrical
lead.
TA168972
Go on to Sheet 2
