TM 5-5420 -226-20-3
SHIFTING CONTROL AND RELATED PARTS REPAIR AND REPLACEMENT (Sheet 10 of 14)
14.
Using vise, press bearing race (S) in
bracket (T) flush with outer surface
of bracket (T).
Using fingers, place bearing (U) into
15.
slots of race (S). Position as shown
in illustration.
16. Using hammer and brass drift, tap link
(V) into place on shaft (K).
17. Using hammer and 1/8 inch punch, install
pin (W) through link (V) and shaft (K).
18. Place bracket assembly (X) on shaft
(K).
19. Using 9/16 inch wrench, install screw
(Y), lockwasher (Z), and washer (AA)
on shaft (K).
Go on to Sheet 11
TA169013
11-11