TM 5-5420-226-20-3
SHIFTING CONTROL AND RELATED PARTS REPAIR AND REPLACEMENT (Sheet 6 of 14)
13.
Using hammer and 1/4 inch drive punch,
remove pin (U) from pivot (AA).
14.
Remove control rod (V) from pivot (AA).
Using flat tip screwdriver, remove adjuster
(W), spring (X), and plunger (Y) from
pivot (AA).
16.
Using hammer and 1/4 inch punch, remove
pin (Z).
17.
Using hammer and 1 inch brass drift,
drive shaft (M) into base assembly (F)
enough to free pivot (AA) and bearing
(AB).
18.
Remove bearing (AB), pivot (AA), and
shaft (M).
INSPECTION:
Inspect pivot (AA), adjuster (W), spring (X),
and plunger (Y) for damage or wear. Replace
as required.
Go on to Sheet 7
TA169009