TM 5-5420-226-3
SERVOBANDS ADJUSTMENT (Sheet 1 of 3)
TOOLS: Torque wrench with 1/2 in. drive (0 to 175 lb-ft) (0 to 237 Nm)
9/16 in. socket with 1/2 in. drive
Ratchet with 1/2 in. drive
1-1/16 in. socket with 1/2 in. drive
1-1/16 in. open end wrench
Socket wrench socket (Item 6, Chapter 3, Section I
SPECIAL TOOLS:
SUPPLIES: Self-locking bolt
REFERENCE: TM 5-5420-226-10
PRELIMINARY PROCEDURES:
Set shift lever in "P" park position (TM 5-5420-226-10)
Remove transmission shroud (page 9-2)
NOTE
Procedures are the same for adjustment of both the low and
reverse bands.
Using 9/16 inch socket, remove self-locking
1.
bolt (A) and washer (B) holding lock plate (C).
Remove lock plate (C).Discard self-locking
bolt (A).
Go on to Sheet 2
11-84 Change 3