TM 5-5420-226-20-3
SHIFT LINKAGE ADJUSTMENT (Sheet 28 of 28)
NOTE
It may be necessary to move indicator pointer
to rear most positional dot to adjust rod end,
and then back to forward most positioned
dot to check adjustment in step 151.
151.
Using 9/16 inch wrench, adjust shifting rod
bearing end (G) by turning clockwise or
counterclockwise until screw (F) will drop
freely through clevis (H) and shifting rod
bearing end (G).
152.
Using 9/16 inch wrench, install screw (F) through clevis (H) and shifting rod bearing end
(G).
Holding rod bearing end (G) with 9/16 inch wrench, use torque wrench and 9/16 inch
153.
crow foot adapter to tighten jamnut (BT) to 16-18 lb-ft (22-24 Nm).
Remove locating pin from alinement hole (C).
154.
155.
Using torque wrench and 9/16 inch socket,
tighten screw (F) to 16-18 lb-ft (22-24 Nm).
156.
Remove blocks from tracks.
Check shifting pattern response (TM 5-5420-
157.
226-10). If transmission still does not shift
correctly, notify support maintenance. If
transmission does shift correctly, go on to
step 158.
Install top deck (page 16-23).
158.
159.
Install transmission shroud (page 9-6).
TA169081
End of Task
11-80