TM 5-5420-226-20-3
BRAKE CONTROL HOUSING REPAIR (Sheet 10 of 14)
17.
Using vise, press bearing (S) into lever
(T).
18.
Position lever (U) assembly on pawl (V)
and start pin (W) through pawl and lever
assembly. Posit ion in vise and press
pin through.
Place large loop of spring (X) over end
19.
of lever assembly (U) and other loop
over end of pawl (V).
20.
Insert lever assembly (U) with its attached parts
through cut out in lever (Y).
NOTE
When installing lever (Y) in
housing assembly (C) make
sure alining mark (dot) on
lever (Y) is in line with wide
slot in shaft (Z).
21.
Slide lever (Y) with its assembled parts on shaft
(z).
22.
Using retaining ring pliers, install snap
ring (AA) in groove of shaft (Z).
Go on to Sheet 11
13-73
