TM 5-5420-226-20-3
BRAKE CONTROL HOUSING REPAIR (Sheet 8 of 14)
5.
Using rule, check that top surface of
hex on stud (F) (the one closest to brake
shaft) stands out beyond transmission
cover surface.
NOTE
If hex of stud (F) (the one closest to
brake shaft) does not stand out beyond
transmission cover surface, add shims
(G). If shims are added, an equal number
should be added to the other stud (F)
(the one farthest from brake shaft).
6.
Using rule, check that end surfaces of
three forward spacer nuts (E) are equal
in height. If they are not, add shims
(H) as necessary between spacer nuts
(E) and housing assembly (C).
Place shim (G) and new packing (J) on
7.
each stud (F).
Position new gasket (K) in groove of
8.
housing assembly (C).
Go on to Sheet 9
13-71