TM 5-5420-226-20-3
PARKING BRAKE CONTROL ASSEMBLY (ENGINE COMPARTMENT) REPLACEMENT (Sheet 6 of 15)
24.
Using two 9/16 inch wrenches, remove
two nuts (AR) by removing lower nut
first while holding upper nut.
Pull control assembly (F) out of housing
25.
(AS). When control assembly (F) is pulled
out, washers (AT), spring (AU), packing
with retainer (AP), and nut (AN) will
fall free.
26.
Throw packing with retainer (AP) away.
Using flat-tip screwdriver, remove and
27.
throw away preformed packing from
inside of nut (AN).
Using screwdriver through holes of both
28.
clevises (AV) to hold, use 9/16 inch
wrench and back off both nuts (AW).
Go on to Sheet 7
13-112
