TM 5-5420-226-20-3
PARKING BRAKE CONTROL ASSEMBLY (ENGINE COMPARTMENT) REPLACEMENT (Sheet 5 of 15)
17.
Using long nosed pliers, remove cotter
pin (AH). Throw cotter pin (AH) away.
18.
Using 9/16 inch wrench, remove nut
(AJ).
19.
Remove two flat washers (AK).
Remove bellcrank (AL).
20.
NOTE
Manually move control assemblies (F) and (S) into "P park
position by pushing both clevis in.
Using 9/16 inch wrench on flats (AM)
21.
of control assembly (F) and 7/8 inch
wrench on nut (AN), back off nut (AN)
until it falls.
22.
Using flat-tip screwdriver, pry packing
with retainer (AP) off control assembly
until it falls onto nut (AN).
23.
Using long nosed pliers, remove cotter
pin (AQ). Throw cotter pin (AQ) away.
TA169235
Go on to Sheet 6
13-111