TM 5-5420-226-20-3
TRACK SUPPORT ROLLER REPLACEMENT (Sheet 3 of 10)
NOTE
If plank or base plate is not available position jack on roadwheel near
roller and raise track.
NOTE
lf hydraulic jack is not available, disconnect track (TM 5-5420-226-10).
Then move vehicle in reverse until track is off of roller.
7.
Using wooden plank or metal plate as base on
roadwheel, position hydraulic jack.
Using jack, raise track so it clears roller.
8.
Safety block must be installed as shown
to prevent injury to personnel in case
of jack failure.
Using 9/16 inch socket, remove six screws
9.
(A), lockwashers (B), and flat washers (C)
securing access cover plate (D) and gasket
(E).
TA169302
Go on to Sheet 4
14-38
