TM 5-5420-226-20-3
SHOCK ABSORBER REPLACEMENT (Sheet 2 of 2)
While one technician holds shock absorber
4.
(D), second technician, using hammer, drive
out upper grooved pin (F).
Remove shock absorber (D).
5.
INSTALLATION:
1.
With one technician holding shock absorber
(A), aline upper eye (B) with hull mounting
bracket (C) and with keyways.
2.
Using fingers, insert upper grooved
pin (D) in position through yoke (C)
and eye (B).
Using long round nose pliers, install
3.
new cotter pin (E). -
4.
Aline lower shock absorber yoke (F)
with roadwheel support arm (G). Aline
keyways by pushing up or pulling down
on yoke.
5.
Using fingers, install lower grooved
pin (H) through shock absorber yoke
(J), with cotter pin hole facing out.
6.
Using long round nose pliers, install
new cotter pin (K).
End of Task
TA169356
