TM 5-5420-226-20-3
SHOCK ABSORBER UPPER MIDDLE AND REAR MOUNTING BRACKETS REPAIR
(Sheet 1 of 2)
TOOLS: Hammer
Remover and replacer
Bushing tool handle
SUPPLIES: Bushing (2 required)
REFERENCES: TM 5-5420226-10
PRELIMINARY PROCEDURE Remove shock absorber (page 14-91)
NOTE
Replacement procedures are the same for
the middle and rear brackets (A and B)
bushings.
REMOVAL
1,
Position remover and replacer (C) on
forward bushing (D) of bracket (A).
2.
Position handle (E) on remover and replacer
(C) and, using hammer, drive bushing (D)
out of bracket (A).
Remove handle (E) and remover and
3.
replacer (C).
Position remover and replacer (C) on rear
bushing (F).
Position handle (E) through bracket (A) on
remover and replacer (C) and, using
hammer, drive bushing (F) out of
bracket (A).
Remove handle (E) and remover and
6.
replacer (C).
Go on to Sheet 2
14-97
