TM 5-5420-226-20-3
STEERING CONTROL LINKAGE ADJUSTMENT (Sheet 18 of 22)
97.
Using 9/16 inch wrench, install screw
(AV).
98.
Using torque wrench and crowfoot,
tighten screw (AV) to 16 lb-ft (22 Nm)
and go on to step 109.
Using 9/16 inch wrench, turn steering rod
99*
end (AW) clockwise until control rod (AZ)
is just past witness hole in steering rod
end (AW).
100.
Using 9/16 inch wrench to hold steering
rod end (AW), use 9/16 inch wrench to
tighten jamnut (AX).
101.
Using 9/16 inch wrench, remove screw
(BA).
102.
Position steering rod end (AW) in clevis
(AY) and using 9/16 inch wrench, install
screw (AV).
Using torque wrench and crowfoot,
103.
tighten screw (AV) to 16 Ib-ft (22 Nm).
Go on to Sheet 19
15-48