TM 5-5420-226-20-3
STEERING CONTROL LINKAGE ADJUSTMENT (Sheet 21 of 22)
Try to insert locating pin (A). If locating
119.
pin (A) can be inserted, go on to step 128.
If locating pin (A) cannot be inserted, go
to step 120.
Using 9/16 inch wrench, remove screw
120.
(BJ).
121.
Insert locating pin (A).
122.
Using 9/16 inch wrench to hold steering
rod end (BK), use 9/16 inch wrench to
loosen jamnut (BL).
123.
Using 9/16 inch wrench, turn steering rod
end (BK) clockwise or counterclockwise
until screw (BJ) can be inserted freely
through clevis (BM) and steering rod end
(BK).
124.
Using 9/16 inch wrench to hold steering rod end (BK), use 9/16 inch wrench tO tighten
jamnut (BL).
125.
Position steering rod end (BK) in clevis (BM) and using 9/16 inch wrench, install screw
(BJ).
127.
Using socket and torque wrench, tighten screw (BJ) to 16 lb-ft (22 Nm).
TA169411
Go on to Sheet 22
15-51