TM 5-5420-226-20-3
STEERING CONTROL LINKAGE ADJUSTMENT (Sheet 20 of 22)
Using hands, turn control rod (BF) clock-
111.
wise until control rod (BF) is just past
witness hole in steering rod end (BG).
Using 9/16 inch wrench to hold steering
112.
rod end (BG), use 9/16 inch wrench to
tighten jamnut (BE).
Remove locating pin (AK).
113.
114.
Position plate (AP) on plate (BH).
Using 9/16 inch wrench, install screw
115.
(AL).
Using 3/4 inch wrench, install nut (AN).
116.
Using pliers, install new cotter pin (AM) through nut (AN).
117.
Install powerplant (page 5-2).
118.
TA169410
Go on to Sheet 21
15-50