TM 5-5420-226-20-3
TOWING PINTLE REPAIR (Sheet 3 of 5)
Using 5/16 inch socket, remove fitting
10.
(L).
11.
Using hammer and 3/8 inch punch, remove
staked pin (M) securing latch (N) to
latch (K).
Remove latch (N) and spring (P) from
12.
latch (K) housing.
Slide sleeve assembly (Q) off towing
13.
pintle (C).
Using screwdriver, remove screw (R) and
14.
chain and cotter pin (E) from towing pintle
(C).
CLEANING AND INSPECTION:
Using 5/16 inch socket, remove fitting (S).
1. Inspect nuts and pintle for excessive 15.
wear or stripping of threads. Replace
as required.
Remove any deformed metal from around
2.
cavity from which pin was removed.
Cleaning agent specified is flammable. Use only in well ventilated areas. keep
away from flames, sparks, or heat. Do not smoke while using. Prevent contact
with eyes, mouth, and/or skin. Wear rubber gloves when performing cleaning
procedures.
3.
Wash lock cavity with dry cleaning sol-
vent and dry with low pressure compressed
air.
ASSEMBLY:
1. Place chain and cotter pin (A) in install-
ation position on towing pintle (B).
2. Using screwdriver, install screw (C) securing
chain and cotter pin (A) to pintle (B).
Go on to Sheet 4
