TM 5-5420-227-24
PERISCOPE MOUNT LID ASSEMBLY REPAIR (Sheet 2 of 3)
CLEANING AND INSPECTION:
Cleaning agent specified is flammable. Use only in well ventilated areas. Keep away
from flames, sparks, or heat. DO not smoke while using. prevent contact with eyes,
mouth, and/or skin. Wear rubber gloves when performing cleaning procedures.
1.
Clean all parts using dry cleaning solvent and steel wool.
Inspect all parts for damage or wear. Replace all unserviceable parts.
2.
ASSEMBLY:
1.
Using vise, squeeze two bearings
(A) into lid (B).
2.
Position bumper (C) on lid (B)
and cover rubber portion with
wet asbestos.
Using welding equipment, weld
3.
metal tongs of bumper (C) to
lid (B).
4.
Remove asbestos from bumper
(c).
5.
Position tab of spring (D)
in slot of retainer of
lid (B).
6.
Insert end of handle (E)
through center of spring
(D) into hole in retainer
on lid (B).
7.
Pull loop end of spring
(D) beyond handle (E)
and release spring over
handle to allow spring to
hold handle against lid (B).
TA170259
Go on to Sheet 3
3-31