TM 5-5420-227-24
EJECTION CYLINDER HOSE ASSEMBLIES (CP1 AND CP2) AND HYDRAULIC REPLACEMENT
(Sheet 1 of 2)
TOOLS: 7/8 in. combination wrench
11/16 in. open end wrench
12 in. adjustable wrench
1-1/4 in. open end wrench
Drip pans
SUPPLIES:
Rags (Item 12, Appendix D)
Pipe tape (Item 19, Appendix D)
Pencil
Preformed packings (4)
Tags, identification
REFERENCE:
PRELIMINARY PROCEDURES:
Remove front quadrant (page 3-39)
Relieve hydraulic pressure (page 3-65)
REMOVAL:
NOTE
Use rags and drip pans to catch excess hydraulic
fluid. Use tags to identify lines for installation.
1.
Using 1-1/4 inch wrench to hold adapters
(A), use 11/16 inch wrench to remove two
hose assemblies "CP1" (B) and "CP2" (C).
2.
Using 1-1/4 inch wrench, remove two
adapters (A) and preformed packings (D).
Throw packings away.
TA170397
Go on to Sheet 2
3-172