TM 5-5420-227-24
LOCKING CYLINDER HOSE ASSEMBLIES (EA1, CP3, CP4 and CS) AND HYDRAULICS
REPLACEMENT (Sheet 3 of 4)
1.
Using adjustable wrench on elbow (A), use
1-1/4 inch wrench to connect hose assembly
"CS" (B).
2.
Manually install nuts (C), flat washers (D),
and preformed packings (E) onto tees (F).
3.
Using adjustable wrench, install tees (F).
Aline tees (F) as shown.
4.
Install sleeve (G) into nut (H).
5.
Using 1-1/4 inch wrench, install nut (H) and
sleeve (G) as an assembly on tee (F).
6.
Using pipe wrench, install coupling (J).
7.
Using pipe wrench on coupling (J), use
adjustable wrench to install and aline elbow
(K), as shown.
8.
Using adjustable wrench to hold tee (F), use
1-1/4 inch wrench to install hose assembly
"CS" (B).
Using 1-1/4 inch wrench on nut (H), use
9.
11/16 inch open end wrench to connect hose
assembly "CP3" (L).
10.
Using adjust able wrench on tee (F), use
adjustable wrench to connect hose
assemblies "EA1" (M) and "CP4" (N).
11.
Using adjustable wrench on elbow (K), use 15/16 inch wrench to install hose assembly "EA1"
(M).
Go on to Sheet 4
TA170401
3-176