TM 5-5420-227-24
MASTER RELIEF VALVE-TO-PUMP HOSE ASSEMBLY (BA) REPLACEMENT (Sheet 2 of 3)
2.
Using 7/16 inch wrench, remove two
screws (C).
3.
Displace interconnector box (D).
4.
Holding elbow (E) with adjustable wrench,
use open end wrench to remove hose
assembly "BA" (A) from elbow (E).
5.
Using adjustable wrench, remove elbow
(E) and collar (F) from tee (G).
INSTALLATION:
NOTE
Before installing, use pipe tape on all
male threads. Start tape on second thread
so tape will not enter hydraulic system.
1.
Using adjustable wrench, install elbow
(A) and collar (B) on tee (C).
2.
Using open end wrench, install hose assembly
"BA" (D) on elbow (A).
3.
Using open end wrench, install hose assembly
"BA" (D) on elbow (E).
4.
Place interconnector box (F) in position.
5.
Using 7/16 inch wrench, install two
screws (G).
6.
G O on to Sheet 3
TA170417
3-192