TM 5-5420-227-24
FILTER-TO-PUMP HOSE ASSEMBLY (CZ) REPLACEMENT (Sheet 2 of 3)
Use adjustable wrench to remove hose
3.
assembly "CZ" (A) from elbow (E).
Using adjustable wrench, remove elbow
4.
(E) and collar (F) from elbow (G).
5.
Holding bushing (H) with adjustable wrench,
use pipe wrench to remove elbow (G)
from bushing (H).
6.
Using adjustable wrench, remove bushing
(H).
NOTE
Nipple (J) may come out with bushing (H).
If it does, nipple (J) may be used again.
7.
Using pipe wrench, remove nipple (J)
from pump (K) and throw nipple away.
INSTALLATION:
NOTE
Before installing, use pipe tape on all male
threads. Start tape on second thread so tape
will not enter hydraulic system.
1.
Manually install nipple (A) in bushing (B).
2.
Using adjustable wrench, install bushing
(B) and nipple (A) in pump (C).
3.
Using adjustable wrench to hold bushing
(B), use pipe wrench to install elbow
(D) on bushing (B).
4.
Using adjustable wrench, install elbow
(E) and collar (F) on elbow (D).
5.
Using adjustable wrench, install hose
assembly "CZ" (G) on elbow (E).
Go on to Sheet 3
TA170419
3-195