TM 5-5420-227-24
OVERHEAD CYLINDER REPLACEMENT (Sheet 6 of 7)
Remove protective caps from hoses and plugs from overhead cylinder.
15.
NOTE
Put pipe tape on male threads of all hydraulic fittings.
Manually install adapter elbow (N) and its
16.
attached parts to overhead cylinder (D).
Using adjustable wrench, tighten adapter
170
elbow (N).
Manually install adapter elbow (P) and its
18.
attached parts to overhead cylinder (D).
Using adjustable wrench, tighten adapter
19.
elbow (P).
20.
Manually install hose assembly "CO" (Q) to
adapter elbow (R) and adapter elbow (S).
21.
Using 1-1/4 inch wrench, tighten nuts of
hose assembly (Q).
CAUTION
Make sure when connecting hose assemblies (T, U, and V) to check for
matching tags. Hose (T) is marked "'CL", hose (U) is marked "CN", hose (V)
is marked "CM".
22.
Manually connect three hose assemblies (T,
U, and V) to elbows (N and W) and adapter
(x).
23.
While holding elbow (N) and elbow (W) with adjustable wrench, use 1-1/4 inch wrench
to tighten nuts to two hose assemblies (T and U).
24.
While holding adapter (X) with 1-1/8 inch wrench, use 1-1/4 inch wrench to tighten hose
assembly nut (V).
TA170447
Go on to Sheet 7
3-224