TM 5-5420-227-24
OVERHEAD CYLINDER REPLACEMENT (Sheet 2 of 7)
Using 1-1/4 inch wrench on nuts of hose assembly "CO" (F) and adjustable wrench on
6.
adapter (G) and adapter elbow (H), remove hose assembly (F).
7.
Using adjustable wrench on adapter elbow
(J), remove adapter elbow (J) and its
attached parts as an assembly.
8.
Using adjustable wrench on adapter elbow
(K), remove adapter elbow and its attached
parts as an assembly.
Put protective plugs in holes that elbow (J)
9.
10.
Using 7/16 inch socket, remove four grease fittings (L).
11.
Position sling around overhead cylinder (M) and attach lifting device (use spreader if
necessary).
WARNING
Make sure sling is wrapped on overhead cylinder (M) so that it cannot slide
loose.
12.
Raise lifting device until sling is tight enough to support overhead cylinder (M).
G O on to Sheet 3
TA170443
3-220