TM 5-5420-227-24
OVERHEAD CYLINDER REPAIR {Sheet 6 of 6)
Service hydraulic reservoir (L0 5-5420-226-12).
18.
Bleed hydraulic system (page 3-66).
19.
Extend overhead piston until rod end (Q) is alined with mount (T) (TM 5-5420-226-10).
20.
Using crowbar, lift overhead cylinder
21.
and remove wooden block from beneath
overhead cylinder (C).
Have one technician position rod end (Q)
22.
in mount (T) while another inserts
pin (R).
Position two retainers (U), one on
23.
each side of mount (T).
Manually install 10 screws (V) and new
24.
lockwashers (W) securing retainers
(U) to mount (T).
Using 1-5/16 inch socket, tighten 10 screws (V).
25.
Check for hydraulic leaks and correct as necessary.
26.
Service hydraulic reservoir (LO 5-5420-226-12).
27.
End of Task
TA170551
4-75