TM 5-5420-228-24
UNIVERSAL JOINT REPLACEMENT (Sheet 2 of 3)
6. Using wrench, remove four screws(J)
and universal joint (K) from yoke (G).
7.
Using wrench, remove four screws (J)
and universal joint (K) from yoke C).
CLEANING AND INSPECTION:
WARNING
Cleaning agent specified is flammable. Use only in well ventilated areas. Keep away
from flames, sparks, or heat. Do not smoke while using. Prevent contact with eyes,
mouth, and/or skin. Wear rubber gloves when performing cleaning procedures.
1.
Clean all parts to be reused in dry cleaning solvent.
Inspect all parts for damage. Replace all unserviceable parts.
2.
INSTALLATION:
Position universal joint (A) on yoke (B)
1.
and manually install four screws (C) in
universal joint.
Position universal joint (A) on yoke (D)
2.
and manually install four screws (C) in
universal joint (A).
3.
Using torque wrench and 7/16 inch crowfoot
wrench, tighten all screws (C) in both yokes
(B and D) to 265 to 325 lb-in (30-36 NZm).
CAUTION
Replace any screws (C) which have
been over torqued beyond 325 lb.-in.
(36 NZm).
TA251463
Go on to Sheet 3
