TM 5-5420-228-24
LOCKING CYLINDER HOSE ASSEMBLIES (EA1, CP3, CP4 and CS) AND HYDRAULICS
RE PLACEMENT (Sheet 3 of 4)
1.
Using adjustable wrench on elbow (A), use
1-1/4 inch wrench to connect hose assembly
"CS" (B).
Manually install nuts (C), flat washers
2.
(D), and new preformed packings (E) onto
tees (F).
Using adjust able wrench, install tees (F).
3.
Aline tees (F) as shown.
Install sleeve (G) into nut (H).
4.
Using 1-1/4 inch wrench, install nut (H) and
5.
sleeve (G) as an assembly on tee (F).
Using pipe wrench, install coupling (J).
6.
Using pipe wrench on coupling (J), use
7.
adjustable wrench to install and aline elbow
(K), as shown.
8.
Using adjustable wrench to hold tee (F), use
1-1/4 inch wrench to install hose assembly
"CS" (B).
Using 1-1/4 inch wrench on nut (H), use
9.
11/16 inch open end wrench to connect hose
assembly "CP3" (L).
10.
Using adjustable wrench on tee (F), use
adjustable wrench to connect hose
assemblies "EA1" (M) and "CP4" (N).
Using adjust able wrench on elbow (K), use 15/16 inch wrench to install hose assembly "E A1"
11.
(M).
Go on to Sheet 4
TA251579
3-182