TM 5-5420-228-24
EJECTION CYLINDER REPLACEMENT (RIGHT) (Sheet 1 of 4)
PROCEDURE INDEX
PROCEDURE
Page
Removal
Installation
TOOLS:
7/8 in. open end wrench
3/8 in. drift punch
Sledge hammer
3/4 in. open end wrench
Flat-tip screwdriver (3/4 to 1 in. across flats)
10 in. adjustable wrench
1-1/2 in. combination box and open end wrench
Wooden block (make from Item 25, Appendix D)
SUPPLIES:
Pipe tape (Item 19, Appendix D)
Protective caps and plugs
Drip pans (suitable containers)
Lockwashers (2 required)
Pencil (Item 22, Appendix D)
Masking tape (Item 18, Appendix D)
REFERENCES:
LO 5-5420-202-12
TM 5-5420-202-10
Extend ejection cylinders (TM 5-5420-202-10)
PRELIMINARY PROCEDURE:
REMOVAL:
NOTE
Use container to catch excess hydraulic fluid. Use masking tape to tag
lines for installation. Cap or plug all lines and fittings as they are
disconnect
Place wooden block under tongue (A) and
1.
lower tongue (A) (TM 5-5420-202-10).
NOTE
It may be necessary to hit plug (B) with sledge hammer
to loosen plug (B).
Using punch in hole of plug (B), unscrew
2.
plug (B) with screwdriver while holding
cylinder rod (C) from turning.
Remove plug (B) from tongue (A).
3.
4. Relieve hydraulic pressure (page 3-71).
