TM 5-5420-228-24
HEU EJECTION CYLINDER (LEFT AND RIGHT) REPLACEMENT (Sheet 4 of 4)
NOTE
Before installation, use pipe tape on all male pipe threads. Start tape on second thread so
tape will not enter hydraulic system. Remove all caps and plugs as necessary during
installation.
6.
Manually place O-rings (G) elbows (H and J).
7.
Manually install elbows (H and J) on ejection
cylinder (A).
8.
Use adjustable wrench to tighten elbows (H and J) on
ejection cylinder (A)
9.
Use adjustable wrench to hold each of two elbows (H
and J) and use 7/8 inch wrench to connect hose
assemblies "AW" (K) and "AX" (L).
10. Bleed hydraulic system (page 3-72).
11. Check for hydraulic leaks and correct as necessary.
12. Service hydraulic reservoir (LO-12).
13. Retract ejection cylinders (TM-10).
H
K
G
A
E
G
J
L
End of Task
3-250.4
Change 3
