TM 5-5420-228-24
HOLDDOWN CYLINDER HOSE GUARD REPLACEMENT (Sheet 1 of 2)
7/8 in. open end wrench
TOOLS:
1-1/2 in. socket with 3/4 in. drive
Ratchet with 3/4 in. drive
Rags (Item 12, Appendix D)
SUPPLIES:
Protective caps and plugs
Pipe tape (Item 19, Appendix D)
Pencil (Item 22, Appendix D)
Masking tape (Item 18, Appendix D)
Lockwashers (2 required)
TM 5-5420-202-10
REFERENCE:
Open No. 3 grille door (TM 5-5420-202-10)
PRELIMINARY PROCEDURES:
Cycle hydraulic levers (page 3-71)
Removal
1.
Using socket, remove two screws (A)
and lockwashers (B) securing hose guard
(C) to vehicle. Throw lockwashers (B)
away.
Cap or plug all lines and manifold (D)
when disconnected. Use masking
tape to tag lines for installation. Use
rags to catch excess hydraulic fluid.
Using wrench, remove hose assemblies
2.
"CV3" (E) and "CV4" (F) from mani-
fold (D).
Slide hose guard (C) off hose assemblies
3.
(E and F).
TA251641
G O on to Sheet 2
3-251
