TM 5-5420-228-24
HYDRAULIC PUMP REPAIR (Sheet 8 of 11)
5.
Manually install spring (H) and flex bearing
(J) in drive shaft (D).
Using hammer and punch, install pin (K) in
6.
shaft (L).
7.
Using arbor press, install two bearings (M)
and washer (N) onto shaft (L).
8.
Using screwdriver, install flat washer (P)
and screw (Q).
Manually install shaft (L) into cylinder block (R).
9.
10.
Using pliers, place retaining ring (S) on retainer (T).
11.
Using pliers, install retaining ring (S) with retainer (T) into cylinder block (R).
12.
Manually install bearing (U) in retainer (T).
Place four knuckles (V) on link and
13.
Holding link and pin assembly (W) a
14.
slide one knuckle (V) into drive shaft (D) with
grooved end up.
15.
Tilt link and pin assembly (W) forward and
install second knuckle (V) in drive shaft (D)
grooved end up.
TA251699
G O on to Sheet 9
4-49