HIGH-BANK LAUNCH OF BAY (cont) - TM-5-5420-278-10

HIGH-BANK LAUNCH OF BAY (cont) - TM-5-5420-278-10_253

HIGH-BANK LAUNCH OF BAY (cont) - TM-5-5420-278-10_255

TM-5-5420-278-10 M85 Tank Chassis Transporting: for Bridge Armored-Vehicle-Launched Scissoring Type Class 80 Manual
Page Navigation
216

TM 5-5420-278-10 0026 00 0026 00-4 HIGH-BANK LAUNCH OF BAY (Contd) WARNING The winch frame must be locked to the LHS hook arm for a high-bank launch. Failure to comply may result in damage to equipment or injury to personnel. NOTE When both winch frame lock levers are in the DOWN position the winch frame is locked to the LHS hook arm. Perform steps i and j if levers are in the UP position. i. Remove quick-release pin (3) from stud (1) at both sides of winch frame (2). j. Swing lever (5) down so that end of stud (4) is through hole in lever (5), and install quick-release pin (3) on stud (4) at both sides of winch frame (2). k. Set both by rotating handle (8) until rear guide (6) guide (6) outboard until latch pin (7) engages 5 8 6 7 2 1 3

Privacy Statement
Press Release
Contact