TM 5-5420-278-10
0031 00
0031 00-2
RAMP BAY TO INTERIOR BAY CONNECTION
(ALTERNATE METHOD ONLY) (Contd)
d. Using taglines connected to belay cleats (1), position front (connecting end) of
ramp bay (3) in line with connecting end of interior bay (8) facing water.
NOTE
Refer to WP 0011 00 for specific instructions on the use
of the coupling device.
e. Using two coupling devices simultaneously, raise ramp bay (3) up until its
roadway surface is even with roadway surface of interior bay (8).
WARNING
Keep hands clear of space between bays when closing
longitudinal upper couplings and do not place fingers
under couplings when closing them, or serious injury to
personnel may result.
f. Close two longitudinal couplings (2) on ramp bay (3) and interior bay (8).
CAUTION
The top of lower lock-drive jackscrew must be 3/4 in.
(1.9 cm) below top surface of roadway for lower lock-
drive pin to be fully engaged. Failure to ensure
jackscrew is 3/4 in. (1.9 cm) below top surface of
roadway may result in damage to equipment.
g. Install T-wrench on jackscrew (4) of lower lock-drive, and turn T-wrench
clockwise until lower lock-drive pin is fully engaged, then back-out jackscrew
(4) one full rotation.
h. Repeat step g for opposite lower lock-drive.
i. Pay-out winch cable (7), disconnect cable hook (6) from load receiving pin (5),
and return transporter LHS main frame to stowed position.
END OF WORK PACKAGE
T-WRENCH
TAGLINE
COUPLING
DEVICE
4
3
2
1
8
7
6
5
SHORE
