TM 5-5420-278-100060 000060 00-2MALFUNCTIONTEST OR INSPECTIONCORRECTIVE ACTIONOperator’s Pump System Troubleshooting (Contd)3. BAP CENTER ROLLER AND/OR TRANSLOAD ROLLERS WILL NOT OPERATEStep 1. Check that pump selector lever is in UP position to operate centerroller or in DOWN position to operate transload rollers.a. If selector lever is in center OFF position, move selector lever toUP or DOWN position and operate hand pump lever (WP 0010 00).b. If desired action(s) is not observed perform step 2 and 3.Step 2. Check hand pump fluid level.If fluid level is low, notify unit maintenance.Step 3. Check for fluid leaks at lines, fittings, and components.a. If leaks are found, notify unit maintenance.b. If problem is not resolved, notify unit maintenance.END OF TESTING4. BAP WINCH ASSEMBLY WILL NOT WIND OUT OR INStep 1. Check that winch assembly switch on remote control unit is set tothe OUT or IN position.Move winch assembly switch to OUT or IN position.Step 2. Check BAP winch lines and fittings for leaks.If leaks are found, notify unit maintenance.Step 3. Check that winch quick-disconnect connectors are properlyconnected to CBT fluid system.a. Disconnect and reconnect quick-disconnect connectors.b. If winch still does not operate, perform step 4.Step 4. Check remote control unit using receptacle on opposite side oftransporter.If winch still does not operate, notify unit maintenance.END OF TESTING
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
