TM 5-5420-278-24&P
0021 00
0021 00-2
FRONT BELLCRANK AND REAR EYEBOLT REPLACEMENT (Contd)
FRONT BELLCRANK REMOVAL
1.
Remove two cotter pins (4) and washers (3) from pin (15), and drive pin (15) out from lever (1) and
front eyebolt (13). Discard cotter pins (4).
2.
Remove two locknuts (9), screws (8), and shackles (2) with lever (1) from inner pontons (12).
Discard locknuts (9).
3.
Remove locknut (14) and screw (6) from front collar (5), and drive front bellcrank (13) forward and
remove collar (5). Discard locknut (14).
NOTE
Note location and number of shim(s) for installation; quantity
may vary between bays.
4.
Drive front bellcrank (13) completely out of inner ponton front hinges (7) and (11) and remove
shim(s) (10).
REAR EYEBOLT REMOVAL
1.
Remove locknut (14), screw (6), and rear collar (17) from rear eyebolt (16). Discard locknut (14).
2.
Drive rear eyebolt (16) completely out of inner ponton rear hinges (7) and (11).
REAR EYEBOLT INSTALLATION
NOTE
Apply grease to shaft of eyebolt at installation.
Install rear eyebolt (16) on inner ponton rear hinges (7) and (11) with rear collar (17), screw (6),
and new locknut (14).
FRONT BELLCRANK INSTALLATION
NOTE
Apply a light coat of grease to shims and shaft of bellcrank at
installation.
1.
Install two shims (10) between front hinges (7) and (11) and push front bellcrank (13) halfway in.
2.
Install front collar (5) over shaft of front bellcrank (13) and push front bellcrank (13) all the way in.
3.
Install front collar (5) on front bellcrank (13) with screw (6) and new locknut (14).
4.
Install shackles (2) on inner pontons (12) with two screws (8) and new locknuts (9).
5.
Install lever (1) with shackles (2) on front bellcrank (13) with two washers (3), pin (15), and two
new cotter pins (4).
6.
Install cable assembly (WP 0020 00).
