TM 5-5420-278-24&P0040 000040 00-4CABLE ASSEMBLY MAINTENANCE (Contd)INSTALLATIONNOTEThe cable connected to right side of bellcrank must pass in frontof cable connected to left side of bellcrank.Ensure cable is routed behind lower lock-drive jackscrew andbumper.1.Route wire cable (4) on inner ponton (12), and connect end of wire cable (4) to bellcrank (1) with pin(2) and new cotter pin (3). Slightly bend protruding end of cotter pin (3).NOTEEnsure tension spring is installed with hook ends pointing towardpontons.2.If removed, install spring (9) on bolt eye (7) with spring pin (6), and connect spring (9) to stabilizerlever (8).3.Perform steps 1 and 2 to install opposite cable assembly.ADJUSTMENTNOTEThe correct cable tension is achieved when the cable can bepushed with the thumb to just touch the ponton wall at a positionapproximately 43 in. (109 cm) from bottom end of cable assembly.1.Loosen two jamnuts (10) on bolt eye (7) and cable end (5), and turn nut (11) counterclockwise untilwire cable (4) is tensioned. Tighten two jamnuts (10).2.Perform step 1 to adjust tension of opposite cable.3.Apply a light coat of lubricating oil to cable assemblies. 4.Install interior bay on transporter (TM 5-5420-278-10).
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
