TM-5-5420-279-10
3.5.1.45
Insert the pins in the highest pin hole position available, from the inside to the outside and
lock in place by fitting the R clip into the outermost hole in the pin.
NOTE
The bank slope will determine the position of the stabilizer leg pins (refer to Chapter 1 Para
3.5.1.46
Lower the A-frame onto the pins.
CAUTION
Equipment damage.
Do not level the A-frame at this stage or the slide frame could be
damaged.
3.5.1.47
Remove the chest pack from its stowage location and connect the chest pack (see 3.4.2)
to its A-frame connection point, using its umbilical cable at either the left hand or right
hand connection point.
Slide Frame Deployment
Select position 3 on the rotary switch in the cab. Make sure the PTO disengages and the
engine rpm reduces to idle. Ensure case lock is engaged (all wheel drive).
