TM-5-5420-279-10
Check for deformation of approach ramp anti-lift bracket. Replace defective
ramp.
Check for deformation of ramp or end beam gutter. Report any defect to
maintenance.
98. Deploy curbs and bridge markers.
Curbs.
Check curb latch assembly for signs of damage. Report any defect to
maintenance.
Check the curb slots, in the panel, for any obstruction. Remove obstructions.
Check the curb hinge bracket for deformation. Replace curb accordance
with Chapter 10 Procedure 10.8.
Check the curb hinge pins for damage. Replace curb in accordance with
Chapter 10 Procedure 10.8.
If bridge module curb hinge bracket is damaged report damage to
maintenance.
Marker.
Check the marker storage location hook for deformation. Replace in
accordance with Chapter 10 Procedure 10.9.
Check marker pivot for damage. Replace in accordance with Chapter 10
Procedure 10.9.
99. Strip out launch beam.
Lower pin can not be extracted from launch beam.
Ensure R clip is removed.
Ensure that the crane IS NOT taking the weight of launch beam.
Ensure that the crane IS NOT pulling the launch beam laterally (side to side).
Check for pin and launch beam jaw damage. Replace defective pin, report
launch beam jaw damage to maintenance.
Upper pin can not be extracted.
Ensure R clip is removed.
Ensure crane IS taking weight of beam.
Ensure crane IS NOT pulling launch beam laterally (side to side).
Check for pin and launch beam jaw damage. Replace defective pin, report
launch beam jaw damage to maintenance.
100. Re-insert launch beam final stop.
Move launch beam forwards or rearward to align holes.
Using BEAM DRIVE mode on the chest pack, move the chest pack right
hand joystick forward or rearward to move the launch beam forward or
rearward slowly as required to allow the launch beam final stop pin to be
inserted.
Check pin for straightness. Replace pin if deformed.
Check launch beam jaw for dirt build up. Clean as required
Check security and alignment of launch beam final stop arms. Report any
defect to maintenance.
101.
Stow all walkways and ladders.
Walkways.
Check for any deformation of walkways. Report any damage to
maintenance.
Ladders.
Check ladder hinge points for damage/obstruction. Report any damage to
maintenance.
Check straps for security. Tighten/report any damage to maintenance.
9-50
