TM-5-5420-279-10
NOTE
The ramp module jaws and dowel end must face the front of the flatrack. Load T1 and V3
have a wooden spacer (Ramp Buffer assembly) to prevent the jaws from fouling the
flatrack.
11.15.1.1
Install buffer to flatrack wall/hookbar (see Figure 11. 116).
11.15.1.2
Fit four bottom location pieces, one at each corner, into convenient stake pockets of
the flatrack. Place a bridge module on to the flatrack using the location pieces as a
guide, positioning the module as close to the buffer on the front of the flatrack as
possible.
CORNER LOCATION PIECE
Figure 11. 97 Corner Location Piece Fitted to Flatrack
11.15.1.3
Fit four transportation aides, two per side, in between the deck units as shown. The
transportation aides being placed between the deck units through which the closing
slings are accessed.
