TM 5-5420-280-10
0007 00
PALLET CONTROLS AND INDICATORS (Contd)
Transload roller bar and mounting screws -- The transload roller bar
and mounting screws can be stowed in either pallet toolbox. The roller bar is
installed on pallet lower support boom with two washers and screws pror to
transloading pallet to PLS trailer. To remove, lift roller bar from toolbox; no
hold-downs are required.
Pallet hold-down bar and launch boom lock wrenches -- The pallet
hold-down bar and launch boom lock wrenches are stowed in each pallet
toolbox. The 2 in. (50 mm) wrench is used to hold turnbuckle while jamnut is
loosened or tightened with 1 5/8 in. (41 mm) combination wrench. The
1 7/16 in. (36 mm) opposite end of the combination wrench is used for
adjusting launch boom lock turnbuckles. No hold-downs are required.
Lower coupling latch hammer -- Each toolbox contains one soft-nosed
hammer used to lock/unlock latch on lower coupling receptacle on each
bridge quarter. No hold-down is required.
Transload roller bar and shoring pads wrench -- There is a 3/4 in.
(19 mm) wrench stowed in each pallet toolbox that is used to remove/install
two transload roller bar mounting screws and four mounting screws on each
shoring pad. No hold-down is required.
LOWER
either toolbox.
PALLET HOLD-DOWN
DRAIN COUPLING
BAR AND LAUNCH
VALVE LATCH HAMMER
BOOM LOCK
TRANSLOAD
PRONGS
HOSE
WRENCHES
ROLLER BAR AND
SHORING PAD
WRENCH
RCU STOWAGE
HOLD-FASTS
BOX KEY
UNLOCKING
AB
ROD
AC
RETRIEVAL
POSITIONING-AID
FASTENING RODS
ROADWAY
MARKER POLES
ANCHORING STRAP
THUMBSCREW
TRANSLOAD
ANCHORING STRAP
CATCH
ROLLER
LEVER
TRANSLOAD ROLLER BAR
AND MOUNTING SCREWS
TOOLBOX LATCHES AND HOLD-DOWN BRACKETS, BII REMOVED
0007 00-13
