TM 5-5420-280-10
0007 00
PALLET CONTROLS AND INDICATORS (Contd)
WARNING
Two personnel are required to remove/install transload
roller bar. Failure to comply may result in injury to
personnel.
AR
TRANSLOAD ROLLER BAR MOUNTING SCREWS -- The transload
roller bar is removed/installed on lower support boom with two mounting
screws. Prior to transloading pallet to PLST, transload roller bar is installed
on pallet lower support boom in transload position. To install, position
transload roller bar on lower support boom, and install two washers and
screws using 3/4 in. (19 mm) BII wrench. Remove and stow bar and mounting
hardware in either pallet toolbox after transloading pallet to CBT.
TRANSLOAD
POSITION
AR
SIDE VIEW
OF PALLET
LOWER SUPPORT
BOOM
TRANSLOAD
ROLLER BAR
WASHER
AR
REAR VIEW OF PALLET
0007 00-19
