TM 5-5420-280-10
0048 00
PALLET MAINTENANCE PROCEDURES (Contd)
LPU ENGINE OIL LEVEL
NOTE
Refer to HATZ Diesel Maintenance Decal Figure for
HATZ engine maintenance intervals.
When checking LPU engine oil level, ensure engine is
stopped and in a horizontal position.
1. Remove dipstick (1) from LPU engine (2), and check oil level on dipstick (1).
2. If engine oil level is below mark (3) on dipstick (1), add oil to oil fill pipe (4)
until oil level reaches upper mark (3) on dipstick (1). Refer to items 10 and 16,
LPU ENGINE OIL BATH AIR FILTER
NOTE
Refer to HATZ Diesel Maintenance Decal Figure for
HATZ engine maintenance intervals.
LPU oil filter oil tank should be supported when
removing clips to prevent oil in tank from spilling.
1. Disconnect two clips (8) from oil tank (10), and remove oil tank (10) and
seal (9) from oil bath air filter housing (7).
2. Inspect seal (9) and replace if damaged.
3. Inspect oil for dirt or contamination. If dirt or contamination is found, notify
field maintenance.
4. Inspect oil level and add oil to oil tank (10) up to mark (11). Refer to items
10 and 16, WP 0052 00.
5. Install seal (9) and oil tank (10) on oil bath air filter housing (7) with two
clips (8).
HATZ Diesel Maintenance Decal Figure.
0048 00-2
