TM 5-5420-280-23&P
0008 00
Electrical System Troubleshooting (Contd).
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
34. RCU WILL NOT RETRIEVE BRIDGE TO PALLET (R10-H) (Contd)
Step 2. Check to see if one or more lights are out when action button 2 is depressed.
a. If light is out, check for 24 volts at control valve solenoid.
b. If connector has 24 volts, replace control valve solenoid or hydraulic control valve. Refer
to WP 0075 00.
c. If connector has no voltage, check wires at KL-1 buss bar pin 1 for KY1 control valve
solenoid, KL-1 buss bar pin 3 for KY3 control valve solenoid, KL-1 buss bar pin 7 for
KY7 control valve solenoid, KL-1 buss bar pin 21 for KY21 control valve solenoid, and
KL-1 buss bar pin 32 for KA8 limit switch. Refer to Electrical System Schematic
d. Check wire between KL-1 buss bar pins 1, 21, and 32 and IQAN-XS connector pins 20,
36, and 25.. Replace wires if damaged. Refer to WP 0053 00.
e. Check wire between KL-1 buss bar pins 3 and 7 and IQAN-XP connector pins 37 and 39.
Replace wires if damaged. Refer to WP 0053 00.
END OF TESTING
35. RCU WILL NOT LIFT LAUNCH BOOM INTO COUPLING POSITION (R9-A)
Step 1. Check that KY1 and KY16 hydraulic control valve solenoid LED lights are lit when action
button 2 is depressed.
NOTE
Potentiometer JR2 is used to stop launch boom at a set position in
the retrieval procedure.
a. If both lights are lit on control valve solenoids, check potentiometer JR2 position 4 to see
if damaged or out of adjustment. Adjust or replace potentiometer JR2. Refer to
b. If potentiometer JR2 is operating and control valve solenoid lights are lit, refer to
malfunction 7 in Hydraulic System Troubleshooting (WP 0010 00).
Step 2. Check to see if one or more control valve solenoid LED lights are out when action button 2
is depressed.
a. If light is out, check for 24 volts at control valve solenoid.
b. If connector has 24 volts, replace control valve solenoid or hydraulic control valve. Refer
to WP 0075 00.
c. If connector has no voltage, check wires at KL-1 buss bar pin 1 for KY1 control valve
solenoid, KL-1 buss bar pin 16 for KY16 control valve solenoid, and KL-1 buss bar
pins 34, 35, and 48 for JR2 potentiometer. Refer to Electrical System Schematic (WP 0122
d. Check wire between KL-1 buss bar pin 1 and IQAN-XS connector pin 20. Replace wire if
damaged. Refer to WP 0053 00.
e. Check wires between KL-1 buss bar pins 16, 34, 35, and 48 and IQAN-XP connector pins
35, 15, 17, and 1. Replace wires if damaged. Refer to WP 0053 00.
END OF TESTING
